User's Manual

Technician Operations

The Installer Settings menu is displayed.

The following Installer operations are available from the Installer Settings menu:

Configure the Entry/Exit

delay periods (page 85)

Configure the Alarm Trans-

mission delay (page 86)

Configure the Swinger Shut-

down feature (page 87)

Reset the TouchScreen to

factory defaults (page 88)

Check for new firmware ver-

sions (page 90)

Manage sensors and zones

(page 94)

Create cross-zone asso-

ciations for sensors (page

104)

Manage the camera (page 112)

Manage the lighting devices (page 125)

Manage thermostats (page 121)

Manage key fobs (page 129)

Manage key pads (page 135)

Manage Panel Interfaces (page 139)

Perform the RMA procedure (page 146)

Reset your managed router (see the TouchScreen User Guide )

Allow or block an unmanaged router passing through the

iControl DMZ (see the TouchScreen User Guide )

Both customers and Installers can test the alarm capabilities by following the procedure described on

page 81.

Testing Alarms

Installers can test the alarm system without going through the entire activation process.

To test alarms (after activation):

1. Call the central monitoring and tell them you are about to test the system.

2. From the Installers Settings app (see page 80), tap Security > Alarm Test.

The Alarm Test Options screen is displayed.