User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
Appendix C: Replacing the TouchScreen Battery
167
Appendix C: Replacing the TouchScreen Battery
The following table lists the battery requirements for the TouchScreen.
Device Device Type Batteries Comments
TouchScreen Central Controller GSP055771 4 volt Lithium Polymer
4400mAh (16.28WH)
Warning: The TouchScreen requires a type GSP055771 battery. This battery should be available only
through the service operator.
1. Use a P1 Phillips screwdriver to remove the (1)
screw from the battery cover of the Touch-
Screen, and detach the cover.
2. Lift the battery out of the receptacle and dis-
connect the battery from the TouchScreen by
gently pulling the base of the connector.
3. Remove the battery from its packaging and
install it in the battery compartment.