User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
Managing Sensors & Zones
159
Figure 107: Connectivity: Router Located Screen
2. Check the MAC address for the router/modem to which the TouchScreen must connect (usually
located at the back of the device).
3. Tap the MAC address for the correct router.
4. Tap Next.
The Configuring and Securing the Router screen is displayed as the TouchScreen establishes a
firm connection with the router/modem, the Broadband servers, and the Cellular connectivity
servers.
Note: This step takes longer than it does during Activation. The items on this screen will vary
based on your particular router.
Figure 108: Connectivity: Configuring and Securing Router Screen
5. Tap Reboot TouchScreen.