User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
150
Figure 93: Connectivity: Ethernet Connection Checklist
14. Follow the instructions on the Connection Checklist screen.
15. Reset the router/modem to factory defaults and then reboot it.
For wireless connectivity, see page 150.
For wired connectivity, see page 151.
For wireless connectivity:
1. Tap Next.
The TouchScreen locates all the available wireless routers in range, and displays their MAC
address.
Figure 94: Connectivity: Setting Up for WI-FI Screen
Home System Installation Guide