User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
Managing Sensors & Zones
143
The Passphrase screen is displayed.
2. Type the passphrase to access the Remove Panel Interface Boards and Zones screen.
A confirmation message is displayed.
3. Tap Yes.
The panel interface and all its zones and sensors are removed from the TouchScreen.
All the PIMs added to the system are deleted. Additionally, all zones connected to the Vista alarm panel
are also removed from the iControl environment.
Notes:
This process might take up to 15 minutes depending on how many zones are connected to the
Vista alarm panel.
A working PIM that is deleted is automatically reset to default mode.
The zones that were previously connected to the Vista System are still connected. If the PIM (or an
upgraded one) is re-paired with the TouchScreen, it finds the zones just as it did before.