User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
Managing Sensors & Zones
139
Figure 85: Settings: Remove Key Pad Screen
3. Tap the icon for the key pad to delete.
A confirmation message is displayed.
Figure 86: Remove Key Pad: Confirmation
4. Tap Yes.
The key pad icon is removed from the Remove a Key Pad screen.
5.
After deleting the key pad from the TouchScreen, press the button to reset the device to
default and place it in Search mode so it can be added to a TouchScreen again.
Managing Panel Interfaces
A MAXIMUM of six IP cameras and 47 ZigBee devices are supported for
the system. ZigBee devices consist of anything that communicates with
the TouchScreen over radio frequency, such as door/window sensors,
lighting devices, thermostats, panel interface devices, key pads, and key
fobs and smoke detectors.