User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
138
2. To modify the system label for the key pad, tap its icon to display a keyboard. Enter a new
name and tap Done.
3. Repeat the previous step to modify additional key pads, or tap Return to Menu to end this
operation.
To reset a key pad to factory defaults:
When a key pad is originally removed from its packaging, it is already in factory default mode. When you
install the battery as described on page 171, it immediately begins searching for a TouchScreen with
which it can pair.
To reset a key pad that has already been added to a TouchScreen and place it in Search mode, delete it as
described on page 138, then press the button.
In the rare event that you need to reset a key pad to factory default that is not paired to a nearby
TouchScreen see page 171.
To delete a key pad from the security system:
1. From the Installer Settings menu, tap Home Devices > Key Pads >Delete Key Pad.
The Delete a Key Pad screen is displayed with images representing the key pads currently
installed to the security system.
Home System Installation Guide