User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
134
7. Repeat the previous steps to modify additional key fobs, or tap Return to Menu to end this oper-
ation.
To reset a key fob to factory defaults:
When a key fob is originally removed from its packaging, it is already in factory default mode. When you
install the battery as described on page 53, it immediately begins searching for a TouchScreen with which
it can pair.
To reset a key fob that has already been added to a TouchScreen and place it in Search mode, delete it as
described on page 134, then press the button.
To delete a key fob from the security system:
1. From the Installer Settings menu, tap Home Devices > Key Fobs > Delete Key Fob.
The Delete a Key Fob screen is displayed with an icon representing each key fob currently
installed to the security system.
Figure 82: Settings: Remove Key Fob Screen
2. Tap the icon for the key fob to delete.
A confirmation message is displayed.
Home System Installation Guide