User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
122
b. Press the Reset button.
The device is reset to factory default.
c. Press the Menu button twice.
d. In the thermostat touch screen tap the Mate label twice (below the radio tower icon).
The Mate label begins blinking to indicate that the device is in Search mode.
When the thermostat device is found, an icon is displayed for that device.
3. Tap Done.
The system notes the number of devices that were found and paired.
4. Tap Next.
The Configure Thermostats screen is displayed showing all the paired thermostat devices.
Home System Installation Guide