User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
110
5. Determine that all the sirens have been located by the TouchScreen.
6. When all the sirens are found, tap Done.
The system notes the number of devices that were found and paired.
7. Tap Next.
The Configure Sirens screen is displayed.
8. Tap a siren to assign a label as described on page 107.
To remove a siren from the TouchScreen:
1. From the Installers Settings menu, tap Home Devices.
The Home Devices menu is displayed.
Home System Installation Guide