User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
104
The tamper switch is located on the circuit board that is at a 90ยบ angle to the casing plane.
4. While pressing and holding the tamper switch, insert a single battery into the smoke detector. The
LED goes ON.
5. After 1 second, release the tamper switch. The LED blinks green.
6. Replace the front cover.
7. Replace all the batteries to the smoke detector and the back cover.
Managing Cross-Zone Associations
A cross-zone association requires the following for an alarm to be triggered:
Two specific sensors are faulted
The sensors are faulted in a particular order
The sensors are faulted within a set time period
Home System Installation Guide