User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
Managing Sensors & Zones
103
4. After 1 second, release the tamper switch. The LED blinks green.
5. Replace the glass break detector cover.
To force default a motion detector:
1. Remove the back cover from the motion detector.
2. Remove the batteries.
3. Remove the front cover.
4. While pressing and holding the tamper switch, insert a single battery into the motion detector.
The front panel LED goes ON.
5. After 1 second, release the tamper switch. The LED blinks green.
6. Replace the front cover and all the batteries to the motion detector.
7. Replace the back cover.
To force default a smoke detector:
1. Twist the back cover of the smoke detector to remove it from the device.
2. Remove the batteries.
3. Use a screwdriver to release the securing tabs that secure the front cover and remove it.