User's Manual
Table Of Contents
- Managing Sensors & Zones
- Maintaining Sensors
- Resetting Sensors to Factory Default
- Managing Cross-Zone Associations
- Managing Sirens
- Managing Cameras
- Managing Thermostats
- Managing Lights
- Managing Key Fobs
- Managing Key Pads
- Managing Panel Interfaces
- Managing Wi-Fi Repeaters
- Replacing a TouchScreen
- Replacing the Security Network Router
- Troubleshooting Router Swapping
- Appendix A: General Concepts of the Security System
- Appendix B: General Info for Sensor Placement
- Appendix C: Replacing the TouchScreen Battery
- Appendix D: Using the Key Pad
- Appendix E: Installer Quick Reference (SIA)
102
To force default a door/window sensor:
1. Find the locking mechanism on the bottom
of the SMCDW01-Z.
2. Holding the SMCDW01-Z in one hand, care-
fully insert the tip of a screwdriver into the
locking mechanism.
3. Push lightly upwards from the back of the SMCDW01-Z until the back plate separates
from the sensor.
4. Remove the battery.
5. While pressing and holding the tamper switch, insert the battery into the SMCDW01-Z,
with the positive (+) end oriented towards the tamper switch. The front panel LED goes
ON.
6. After 1 second, release the tamper switch. The LED blinks green.
7. Replace the SMCDW01-Z back plate.
To force default a glass break detector:
1. Remove the cover from the glass break detector.
2. Remove the battery.
3. While pressing and holding the tamper switch, insert the battery into the glass break detector.
The front panel LED goes ON.
Home System Installation Guide