User's Manual

Product Manual – Genie Air
TM
Version 1.3.0 – 11/22/2016
Page 25 DIRECTV, Inc. Proprietary and Confidential
功
功功
功能變
能變能變
能變數代
數代數代
數代碼變
碼變碼變
碼變更
更更
更
VI. M ANAGE (R EPLACE & R EMOVE )
A. REPLACE GENIE AIR
TM
The following are steps to be followed when the user needs to replace an old Genie Air
TM
with a new one.
1) Swap the old Genie Air
TM
with the new Genie Air
TM
.
2) Follow normal steps to Reset Connection (Reset to Default) on the Wireless
Client (if any).
3) Activate the new Genie Air
TM
as described in the Installation (Genie Air
TM
Boot-
Up & Activation) section V.A.2 above.
4) Follow the steps to add a client as described in the Installation (Add A Client)
section V.C above and pair all the clients to the new Genie Air
TM
.
B. REPLACE CLIENT
Full Client Tracking process is used to Add / Replace clients.
1) To replace a client, Follow the steps in the Installation (Client Installation)
section V.B above to swap the old client with the new client.
2) If using a Wireless Client, press the Add Client button at the top of the Genie
Air
TM
and select Connect Now on the wireless client.
3) Select Replace a Location.
4) Follow the Full Client Tracking steps to replace the Client. Refer D-088 Goliath-
Flower Tech Comm for detailed information (Refer the Appendix). See “Replace
an RVU Client when in Lenient Mode or when in FCT mode” section III.B.3.c
C. REMOVE CLIENT
The Genie Air
TM
should always have at-least one client connected to it. These steps are to
be followed only to remove the 2nd through 8th clients and not when replacing a client.
1) Physically remove the specific client.
2) From another client location select Menu -> Settings -> Whole-Home -> Manage
Clients -> Remove Locations.
3) Follow the Full Client Tracking steps to remove the client. Refer D-088 Goliath-
Flower Tech Comm for detailed information (Refer the Appendix). See “Delete
or Remove a Client when in Lenient Mode or when in FCT mode” section III.B.4
D. REPLACE EXTERNAL WVB
The Internal Video Bridge cannot be removed as it is built-into the Genie Air
TM
. If an External
WVB is configured to the network, the “Remove Video Bridges” option will be enabled.
The following are the steps to be followed when removing an External WVB.
1) Ensure the Genie Air
TM
server is has powered On.
2) Ensure all the Wireless clients are turned Off (in standby).
3) Physically remove the old WVB.