User Manual Part 1

Plug the other end into a working electrical outlet or power strip.

Make sure that the outlet is not controlled by a

switch that gets turned on and o.

Check the front of the HD-DTA to see if the green light is on and blinking.

If it is not on, check to make sure the power plug was plugged

into the power input “+

5V DC In” and that the other end

is plugged into a working electrical outlet.

Note: After activation, this light will remain on and constantly lit.

Please wait 20 minutes before calling to activate.

This will allow the HD-DTA to connect to the

network and get the latest updates.

C 25M 75Y 50K CY GB50 75M 25Y K 25C MY GB75 50C GB25 M 50Y 25K CM P 75C 50M Y 75K