User's Manual

The RX38Ur is designed to power up to two full-range passive loudspeakers and three surround speakers.
The speakers should be connected via the speaker wire outputs on the rear of the RX38Ur.
Connecting the RX38Ur to Passive Loudspeakers
Screen Display
RX38Ur
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
iPod™ & iPhone™ is a registered trademark of Apple Computers, Inc. Apple Computers, Inc. is not endorsing, sponsoring, or otherwise affiliated with this
manufacturer.
Accessories Included: Power cable, MP3 cable,antenna,remote,manual,warranty and catalog.
NOTE: WHEN MAKING THESE CONNECTIONS THE POWER OF THE RX38Ur AND THE SIGNAL
SOURCE SHOULD ALL BE IN THE OFF POSITION WITH THE VOLUME LEVELS TURNED DOWN.
ONCE
THE UNITS ARE ALL POWERED ON, SLOWLY INCREASE THE VOLUME TO AVOID DAMAGING ANY
OF YOUR EQUIPMENT. THE RX38Ur OPERATED MOST EFFICIENTLY WHEN USED WITH 8 OHM
SPEAKERS.
1
4 5 6 7 8 9
2 3
1.REP ONE: This will illuminate when the unit is set to repeat the current track when playing signal from USB
flash drive or SD card.
2.PLAY/PAUSE: This will illuminate when the unit is playing signal from USB flash drive or SD card and it will
flash when the playing is paused.
3.REP ALL:This will illuminate when the unit is set to repeat all tracks when playing signal from USB flash drive
or SD card. The default setting is repeat all tracks.
4.TUNER: This will illuminate when the tuner input is selected.
5.DVD: This will illuminate when the DVD input is selected.
6.AUX: This will illuminate when the AUX input is selected.
7.MP3: This will illuminate when the MP3/SD/USB input is selected.
8.SD/USB: This will illuminate when the SD/USB/MP3 input is selected.
9.Sound Meters: This will dynamically illuminate when the unit is playing.