315-4PN33

Perform a hardware configuration for the CPU.

Chapter 5.4

‘Hardware configuration - CPU’ on page 40

2. Configure always as last module a Siemens DP master CP

342-5 (342-5DA02 V5.0). Connect and parametrize it at opera-

tion mode "DP-Master".

3. Connect the slave system "VIPA_SPEEDbus". After installing

the SPEEDBUS.GSD this may be found in the hardware catalog

at Profibus-DP / Additional field devices / I/O / VIPA /

VIPA_SPEEDBUS.

4. For the slave system set the PROFIBUS address 100.

5. Configure at slot 0 the VIPA CPU 315-4PN33 of the hardware

catalog from VIPA_SPEEDbus.

6. By double clicking the placed CPU 315-4PN33 the properties

dialog of the CPU may be opened.

5.8.2

VIPA specific parameters

The following parameters may be accessed by means of the proper-

ties dialog of the VIPA-CPU.

5.8.2.1 Number remanence flag

Here the number of flag bytes may be set. With 0 the value Retentive

memory > Number of memory bytes starting with MB0 set at the

parameters of the Siemens CPU is used. Otherwise the adjusted

value (1 ... 8192) is used. Default: 0

5.8.2.2 Priority of OB 28 and OB 29

The priority fixes the order of interrupts of the corresponding interrupt

OB. Here the following priorities are supported: 0 (Interrupt-OB is

deactivated), 2, 3, 4, 9, 12, 16, 17, 24. Default: 24

5.9 Project transfer

There are the following possibilities for project transfer into the CPU:

n Transfer via MPI

n Transfer via Ethernet

n Transfer via MMC

5.9.1 Transfer via MPI

For transfer via MPI there is the following interface:

n X2: MPI interface

Overview

VIPA System 300S Deployment CPU 315-4PN33

Project transfer > Transfer via MPI

HB140 | CPU | 315-4PN33 | GB | 14-43 49