315-4PN33

7. Confirm with [Assign IP configuration].

Directly after the assignment the PROFINET interface is

online reachable using the set IP address data. The value

remains as long as it is reassigned, it is overwritten by a

hardware configuration or an factory reset is executed.

Due to the system you may get a message that the IP

address could not be assigned. This message can be

ignored.

1. Open your project.

2. If not already done, configure in the ‘Device configuration’ a

Siemens CPU 315-2 PN/DP (6ES7 315-2EH13-0AB0 V2.6).

3. Configure the System 300 modules.

4. Open the "Property" dialog by clicking on the ‘PROFINET

interface’ and enter for PROFINET interface "Properties" at

‘Ethernet address’ the IP address data, which you have

assigned before.

5. Transfer your project.

Take IP address param-

eters in project

VIPA System 300SConfiguration with TIA Portal

TIA Portal - Hardware configuration - PG/OP via PROFINET

HB140 | CPU | 315-4PN33 | GB | 14-43 154