315-4PN33

Device overview:

Module ... Slot ... Type ...

PLC ... 2 CPU 315-2 PN/DP

MPI/DP inter-

face

2 X1 MPI/DP interface

PROFINET

interface

2 X2 PROFINET interface

... ... ...

Since the CPU from VIPA is configured as Siemens CPU, so the set-

ting of the parameters takes place via the Siemens CPU. For para-

metrization click in the Project arearespectively in the Device over-

view at the CPU part. Then the parameters of the CPU part are

shown in the Properties dialog. Here you can make your parameter

settings.

on page 44

9.3 TIA Portal - Hardware configuration - I/O modules

After the hardware configuration of the CPU place the System 300

modules at the bus in the plugged sequence. For this drag&drop the

according module from the Hardware catalog to the according posi-

tion of the profile rail in the Project area or in the Device overview

Setting standard CPU

parameters

Hardware configuration

of the modules

VIPA System 300S Configuration with TIA Portal

TIA Portal - Hardware configuration - I/O modules

HB140 | CPU | 315-4PN33 | GB | 14-43 149