315-4PN33

The configuration of the function Device replacement without
exchangeable medium/PG in your PROFINET IO system happens
with the following approach:
1. Double-click at the PROFINET interface of the IO controller of
the CPU.
ð
The properties dialog of this PROFINET interface is opened
2. Enable in the register ‘General’ the option ‘Support device
replacement without exchangeable medium’ .
3. Apply the settings with [OK].
4. Safe and translate the hardware configuration.
5.
Configure your Topology.
Ä Chapter 8.10 ‘Topology - Configu-
ration’ on page 139
6. Transfer your project to the CPU.
8.11.1
Replace device
For the replacement the "replace device" must be in "delivery state".
If you have not received a new "replace device" from VIPA, you have
to prepare this with the following approach:
1. For this connect your "replace device" local at your PG.
2. Start the Siemens SIMATIC Manager and execute ‘PLC
è Edit Ethernet node
’
3. Click at ‘Nodes accessible online’ at [Browse].
4. Select the according IO device, which you identify as your
"replace device".
5. Click at ‘Reset to factory settings’ at [Reset].
ð
Your IO device is now reset and has then "delivery state".
For the replacement the "replace device" must be in "delivery state".
1. Disconnect if not already done your device to be exchanged
from power.
2. Replace this by your "replace device".
3. Connect the "replaced device" to power and turn it ON.
ð
Here by comparison of target and current topology, the
"replaced device" is automatically detected by the IO con-
troller and automatically integrated to the user data traffic.
8.12 Commissioning and start-up behaviour
In the delivery state the CPU is overall reset. The PROFINET part is
deactivated and its LEDs are off after PowerON.
Configuring the func-
tion
Prepare the replace
device
Replace device
Start-up on delivery
VIPA System 300S Deployment Ethernet communication - PROFINET
Commissioning and start-up behaviour
HB140 | CPU | 315-4PN33 | GB | 14-43 141