315-4PN33

Please consider that this SPEED7-CPU has 4 ACCUs.

After an arithmetic operation (+I, -I, *I, /I, +D, -D, *D, /D,

MOD, +R, -R, *R, /R) the content of ACCU 3 and ACCU 4

is loaded into ACCU 3 and 2. This may cause conflicts in

applications that presume an unmodified ACCU 2.

For more information may be found in the manual "VIPA

Operation list SPEED7" at "Differences between SPEED7

and 300V programming".

To be compatible with the Siemens SIMATIC Manager the following

steps should be executed:

1. Start the Siemens hardware configurator with a new project.

2. Insert a profile rail from the hardware catalog.

3. Place at ‘Slot’ -Number 2 the CPU 315-2 PN/DP (315-2EH13

V2.6).

4. The PROFINET IO controller is to be configured via the sub

module ‘X2 PN-IO’ .

8.7

Parameters - PROFINET IO controller

8.7.1 Precondition

To parametrize the PROFINET IO controller of the CPU, the following

conditions must be fulfilled:

n The PROFINET IO controller is online reachable, this means an

initialization was established.

n The hardware configuration described before was established and

the PROFINET IO controller is networked.

Open the properties dialog of the PROFINET IO controller by a

double-click at PN-IO.

The PROFINET interface of the PROFINET IO controller is parame-

trized with PN-IO, the port with Port 1. In the following these parame-

ters for PN-IO and Port 1 are described.

Proceeding

VIPA System 300S Deployment Ethernet communication - PROFINET

Parameters - PROFINET IO controller > Precondition

HB140 | CPU | 315-4PN33 | GB | 14-43 135