Installation & Assembly

CHAIR’S FUNCTIONS:
(1) To raise or lower the chair’s height, pull UP the lever that is under the seat. The chair goes down while
sitting on it, or up if you lift your body.
(2) To make the chair tilt, pull the same lever OUT horizontally to unlock this function, and IN to lock again.
(3) To adjust the tension for the tilting function, turn the mechanism’s knob in either direction to apply more
or less tension.
(4) To make the backrest recline, pull UP the lever that is located on the rear right side of the seat and release
it when the desired position is reached.
WARNING: For your safety, the chair’s tilt function in the mechanism should be in the LOCKED (IN)
position prior to use the backrest reclining function.
(5) To adjust the armrest height, pull UP the button that is under the armrest and release it once the
desired height is reached.
(6) To adjust the armrests sideways, just turn them manually to the desired position right to left or left to right.
WARNINGS:
• Do not stand up on the chair or use it as ladder.
• Use the chair to seat only one person at a time.
• Do not use the chair if parts are damaged or if screws are loose or missing.
• Do not seat near the edge of the seat and always sit properly on the chair to avoid going beyond your balance point and fall off the chair.
• The chair is intended for teenagers and adults. If small children are using the chair, please keep close observation on them.
• Do not allow small children to play with the chair.
• Not paying attention to these warnings could result in severe injuries.
CARE AND MAINTENANCE:
• To clean the chair it is recommended to use a soft cloth lightly damped in a solution of smooth soap and water, then dry with a clean towel.
• Do not use solvents or abrasive materials to clean any part of the chair.
• Before applying a cleaning agent, test on a small hidden area of the chair, like underneath the seat.
• Do not expose the product to direct sunlight or to extreme environmental conditions.
• Every 4 months, inspect the chair completely and make sure that all screws are tighten.
(1)/(2)
(3)
(4)
(6)
(5)