Instructions / Assembly

P. 7
RTA-TS201
P. 7
With the parts oriented as shown, first insert the screw E in the center
hole of the top support tube 5. Then insert the connector tube 7 to the
screw E. Finally, insert one screw D through the center hole of the
bottom support tube 6 and screw it into the tube 7 as shown.
DO NOT TIGHTEN THE SCREW YET TO ALLOW FLEXIBILITY FOR
THE NEXT STEP.
With the help of another person, assemble the structures 5 and 6 to the
structures in “L” 8 and 9 using screws A and O-rings G as shown.
If the holes don’t align, review steps 4 and 5 for assembly errors.
You can now proceed to tighten the screw D from the previous step.
STEP 5
Hardware/tools:
D
M6x35
1
Pc
E
M6x40
1
Pc
5
6
9
8
Top tube
Bottom tube
FIRST
SECOND
5
6
7
D
E
THIRD
Make sure both
tubes are oriented
the same.
STEP 6
Hardware/tools:
A
M6x12
4
Pcs
G
Ø10mm
4
Pcs
AG