Instructions / Assembly

37
57$%
37
Use screws ( C ) to fix the Lateral structure ( 9 ) to left and right panels ( 1 ), ( 2 ) and
to the bottom panels ( 7 ).
STEP 
Screws:
C
6x35mm
x6
6FDQ45&RGHWR
YLHZWKLVVWHS
1
2
9
7
STEP
Screws:
'
6x40mm
x6
6FDQ45&RGHWR
YLHZWKLVVWHS
1
2
4
First screw the bolts ( D ) to the top panel ( 8 ), then place
it down and assemble it to the structure by turning the
cam locks on panel ( 1 ), ( 2 ) and ( 4) as shown and as
explained in page 3.
8
First place the curved connector and washer ( I ) over the open hole on structure ( 10 ),
then place the Right Tilting Mechanism ( 13 ), and finally insert the Screw Knob ( 16 ) and
tighten to secure the parts as shown. Repeat the same procedure with the Left Tilting
Mechanism ( 14 ).
STEP 
Screws:
,
x2
6FDQ45&RGHWR
YLHZWKLVVWHS
10
10
13
14
16
16
25x15mm
⚠ IMPORTANT:
The washer goes in between
the curved support and the
tilting plate