Instructions / Assembly
Table Of Contents
- Page 0 (Front cover)
- Page 1 (Important messages)
- Page 2 (Main Parts list)
- Page 3 (Main parts layout, Hardware List)
- Page 4 (Cam Bolt-Lock tutorial)
- Page 5 (Tips and warnings)
- Page 6 (Steps 1, 2)
- Page 7 (Steps 3, 4)
- Page 8 (Step 5)
- Page 9 (Step 6)
- Page 10 (Step 7)
- Page 11 (Step 8)
- Page 12 (Steps 9, 10)
- Page 13 (Steps 11, 12)
- Page 14 (Steps 13, 14)
- Page 15 (Step 15, DONE message)
- Page 16 (Weight limits, Warnings, Care)
- Page 17 (Warranty)
- Page 18 (Back cover)
P.4 P.4
RTA-8404
1. Screw the bolt into the indicated hole on the
panel indicated in the assembly step.
CAM BOLT AND CAM LOCK TUTORIAL
THE INSTRUCTIONS BELOW ARE NOT ACTUAL ASSEMBLY STEPS
This unit uses cam bolts and locks (also known as mini fixes).
If you are not familiar with this kind of hardware, the below is a tutorial
that explains how to use them on the steps where they are required.
2. Join the other panel (with the big hole) to the
panel with the bolt. If it comes with the cam
locks already pre-installed, make sure to align
them to receive the bolt's head (refer to point
3). There might be a very small gap between
the panels which is normal.
3. Insert the cam lock on the panel with the big
hole making sure it goes aligned to receive the
bolt's head.
4. Use a Phillips screwdriver to turn the cam
lock clockwise. This will lock the panels
togheter and also will close any gaps.
Cam lock
alignment
If the cam locks come
pre-in stalled, make sure they
are aligned (see point 3).