Instructions / Assembly

P.15 P.15
RTA-8404
Insert the drawers into the unit starting with the bottom, then middle, then top
drawer. You might have to insert them at an angle facing down.
NOTES:
If the drawers stop halfway, check and make sure that the screws inside
the unit and on the drawer are properly tightened and their heads don't
protrude or interfere with the drawers' rollers.
If the drawers don't seem to fit, review the assembly of the sliders in page
7 step 4, and page 14 step 14 for the correct assembly.
STEP 15
Scan QR to view step
Give yourself a nice pat on the back, you did a great job!
ALL DONE!
ENJOY YOUR NEW UNIT!
If the drawers stop and do
not enter completely, tighten
the screws inside the unit as
flush as possible.
If the drawers don't seem to
fit, review the assembly of
the sliders in page 7 step 4,
and page 14 step 14.