Instructions / Assembly

RTA-739DL
P.7
P.7
BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.
•
•
•
•
•
•
•
•
Do not discard this manual or any of the packaging
material until the unit has been completely assembled.
If during assembly you find an issue or need
clarification, please contact our Customer Service
for assistance. Please refer to the last pages on this
manual.
√
√
M6
30mm
M6x30
•
On each step, read the instructions throughly and
analyze the illustrations before proceeding to do the
assembly.
Follow the instructions step by step and do not skip
any unless our Customer Service advises it is OK to
do so.
Make sure you understand which hardware,
will be used on each step. Using the wrong
size of screw, bolt or pin might strip the
threads or cause damage to the part in
which it is being used.
To avoid misalignments, always leave the screws
loosely and do not tighten them until all the pieces are
positioned correctly.
Do not overtighten or force the screws as they might
break, strip, damage the threads of the holes, or get
stuck inside the parts.
If the hole seems to small for the screw, make sure
you are using the correct size of screw and/or that you
are installing it in the correct hole.
Sometimes on the panels the laminate or material
might be covering the hole partially or entirely, so if the
is no visible hole or if it loos too small, pass and press
the tip of your finger over the area where the hole
should be located to feel its indentation, and once
found, carefully pierce the laminate to uncover the hole
underneath.