MODEL RTA-4907 ASSEMBLY INSTRUCTIONS Thank you for purchasing our product. REV.
RTA-4907 P.1 P.
P.2 RTA-4907 P.2 BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS. ❶ Do a quick inventory to make sure the package contains all the parts and hardware listed in the assembly instructions. ❻ Make sure you understand which hardware will be used on each step. Using the wrong size of screw, bolt or pin might strip the threads or cause damage to the part in which it is being used. ❷ Missing, damaged and defective parts can be replaced at no cost to you.
RTA-4907 P.3 P.3 ASSEMBLY STEPS STEP 1 Insert the casters F into the legs of the base C using pressure, then place the gas lift E in the middle of the base, and cover it with H as shown. H E C F STEP 2 Hardware I M6x20mm 4 Pcs 4 Pcs Place the seat B upsidedown and assemble the mechanism D with screws I making sure the tension knob faces towards the front as shown. D B STEP 3 Put the seat over the base parts making sure the tip of the gas lift E enters into the hole of the mechanism D.
RTA-4907 P.4 STEP 4 Hardware I M6x20mm 4 Pcs P.4 Assemble the armrests G to the seat B in their corresponding side with screws I, BUT LEAVE ALL THE SCREWS VERY LOOSE to allow flexibility for the next step. G-L LEFT G-R RIGHT STEP 5 Hardware I J M6x20mm 4 Pcs B • Assemble the backrest A to the arms G with screws I, and proceed to tighten all the screws from step 4 and 5. • Cover the screw holes with J. 8 Pcs A G-R ALL DONE! G-L I J Give yourself a nice pat on the back.
RTA-4907 P.5 P.5 CHAIR’S FUNCTIONS ① To raise or lower the chair’s height, pull UP the lever that is under the seat. The chair goes down while sitting on it, or up if you lift your body. ② To make the chair tilt freely, pull the same lever OUT horizontally to unlock this function. When the chair is in the normal upright position, push the lever IN to lock again. ③ To adjust the tension for the tilting function, turn the mechanism’s knob in either direction to apply more or less tension.
P.6 RTA-4907 P.6 TECHNI MOBILI CHAIR WARRANTY TASK/KID'S CHAIR: 1-YEAR WARRANTY EXECUTIVE/MANAGER CHAIR: 2-YEAR WARRANTY 1.RTA Products, LLC has warranted the Techni Mobili office chairs to the original purchaser who acquired a new product from RTA Products or its authorized resellers of the product against defects in material or workmanship. 2.
P.7 RTA-4907 P.7 FOR SEVERAL HELP OPTIONS INCLUDING REPLACEMENT PARTS ORDERS _________________________________________________________________ VISIT: WWW.TECHNIMOBILI.COM CLICK ON SUPPORT TAB Scan QR Code to order replacement parts OR EMAIL US: SUPPORT@RTAPRODUCTS.
