Instructions / Assembly

RTA-3263C
P.5 P.5
• To clean the chair it is recommended to use a soft cloth lightly damped in a solution of smooth
soap and water, then dry with a clean towel.
• Do not use solvents or abrasive materials to clean any part of the chair.
• Before using a cleaning agent, test on a small hidden area of the chair, like underneath the seat.
• Do not expose the product to direct sunlight or to extreme environmental conditions.
• Inspect the chair completely every 4 months and make sure that all screws are tightened.
CHAIR'S FUNCTIONS
CARE AND MAINTENANCE
WARNINGS
• Do not exceed the indicated weight limit.
• Do not use if parts are bent, damaged, or if screws are loose or missing.
• Only one person at a time can sit on the chair.
• Do not sit babies or toddlers alone.
• If children (3 years and older) are sitting on the chair, always keep close
observation on them.
• Do not allow small children to play with the chair.
• Do not stand up on the chair or use it as ladder.
• Do not sit too close to the edge of the seat to avoid going beyond your
balance point and falling off the chair, and always sit properly.
• Not paying attention to these warnings could result in injuries.
WEIGHT LIMIT
250
Lbs
(113.6 Kg)
To raise or lower the chair’s height, pull UP the lever that is under the seat on the right side.
The chair goes down while sitting on it, or up if you lift your body.
The chair also tilts freely by pulling OUT the same lever to unlock this function.
The mechanism under the seat has a tension knob at the front that you can turn either way to
apply more or less tension to the tiltilng function. With less tension, the tilting will feel easier.
You can flip-up the armrests to use the chair as if it was armless.
You can adjust the headrest heigth by just pulling UP or pushing DOWN on the headrest.
You can adjust the lumbar support height by pulling UP or pushing DOWN on the lever on the
back of the backrest.
1
2
3
4
5
3
TENSION
2
1
4
CHAIR HEIGHT
TILTING
FLIP-UP
6
ADJUST
5
ADJUST
6