Installation Manual

P.10
Use Screws (G) to affix the Slider Bases (16) to the
Main Panel (14).
Use Screws (H) to fix the Keyboard Slider (15) to
the Slider Bases (16) as illustrated. Please note
the position of the tabs on the sliders.
First screw the Bolts (B) to the corresponding holes on the Main Table
Top (14). Then, position both portions of the desk as shown in the
illustration, and while the second person holds the cabinet, assemble
the Main Table Top (14) to the Right Back Panel (9) as illustrated, place
the plastic washer (M) in between the Short Support Tube (13) and the
Top Panel (11), and finally turn the corresponding cam locks. The Long
Tube (6) will hold the table top on that side, and will get assembled in the
follow step.
ATTENTION: A second person is required to assist with this step.