Instructions / Assembly

ASSEMBLY STEPS

P.4

RTA-2018

P.4

Using the wrench, assemble the casters ② to the structures ①L, ①R in the following

order:

☛ The locking casters ②L go on the front bottom holes,

☛ The non-locking casters ②N go on the back bottom holes.

First check and make sure of the correct alignment of the inserts in the back panel ③, then

use screws Ⓐ to assemble it to the structures ①L and ①R as shown.

If the inserts are misaligned,

use a flat head screwdriver

to re-align them.

STEP 1

STEP 2

Screws:

Ⓐ

6x45mm

Pcs

Panel ③ comes with metal inserts on its interior face, they look like screws but are nuts

pre-aligned to receive the screws. Sometimes misalignments occur, and you will have to use

a flat head screwdriver (not included) to turn and align the inserts as shown below.

YES √NO X

The middle and

lower bars face

towards the inside.

Locking at front

Non-locking at back