P.1 ASSEMBLY INSTRUCTIONS MODEL RTA-2012 Thanks for purchasing one of our products. Please read carefully the assembly instructions before the installation. Please save this manual for future reference. P.
RTA-2012 P.2 Main Structure, x2 Studs, x4 Crossbars, X1 SET M6x40, x4 P.2 Horizontal Tube, x2 M6x15, x4 Tabletop, x1 M6x30, x6 Allen Wrench, x1 ⚠ BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS. ☛ Do a quick inventory to make sure the product contains all the parts and hardware. ☛ Missing, damaged and defective parts can be replaced at no cost to you. Please refer to the CONTACT and the WARRANTY cards included with the product.
P.3 RTA-2012 P.3 Assemble the horizontal tubes (3) at the top of the main structures (1) using screws (B), the crossbars (2) at the back using screws (C), and the studs (A) at the bottom as shown. Assemble the tabletop (4) to the horizontal bars using screws (D) as shown. Proceed to tighten all the screws.
P.4 RTA-2012 P.4 ⚠ AFTER THE ASSEMBLY IS DONE, PLEASE READ THE FOLLOWING WARNINGS FOR CARE AND MAINTENANCE: ☛ Do not expose the surfaces to direct sunlight or to extreme environmental conditions. Damages caused by this kind of exposure is not covered by the product’s warranty. ☛ Clean the surfaces preferable with a soft cloth damped with a solution of mild soap and water, then dry with a clean towel. Damages caused by the use of solvents or abrasive materials are not covered by the product’s warranty.
