Instructions / Assembly

ManualsBrandsTechni Mobili ManualsDesk ChairsTechniMobili Black High Back Executive Mesh Office Chair with ArmsHeadrest and Lumbar Support

PARTS LIST

ATTENTION: Before you begin to assemble the

product, please make sure that all the parts are

included in the package and in good condition.

ASSEMBLY INSTRUCTIONS

CHAIR STYLE RTA-1009

Insert the casters (F) in the legs of the

base (C) using pressure, then place the

gas lift (E) and the cover (I) in the middle

of the base as shown.

Flip over the seat (B) with its front

towards you and assemble the armrests

(G) in the respective sides using screws

(K) as shown.

Assemble the backrest (A) to the

mechanism (D) from underneath using

screws (M) and washers (O) as shown.

NOTE: The position of the backrest

(forward or backward) depends on which

set of 4 holes you choose on the seat to

install the mechanism.

Assemble the mechanism (D) to the seat

(B) on one of the sets of 4 holes using

screws (L) and washers (O) as shown.

Place the top parts over the base parts

making sure the tip of the gas lift enters

into the hole of the mechanism.

Before seating and using the chair for

the first time, make sure that all

screws are properly tightened.

G (Right)

G (Left)

L+O

M+O

5-Star base

Backrest

Mechanism

Hydraulic

Gas Lift

Casters

Seat

Ø 6x25mm

Base Cover

Headrest

Ø 8x20mm

(Backrest)

(Armrests)

(Mechanism, backrest)

Ø 6x30mm

(Mechanism)

ATTENTION:

• Follow the instructions step by step.

• To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.

• Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.

• Using the wrong size of screws on a part could result in damage to the screw or the part

2 3

5 6

Assemble the headrest (J) to the

backrest (A) using screws (N) as shown.

Allen wrench 6mm

Allen wrench 5mm

When you seat on the chair, not looking at it.

Washers

(Headrest)

Allen wrench 4mm

Left

Armrests

Right

J N

Summary of content (2 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS CHAIR STYLE RTA-1009 PARTS LIST ATTENTION: Before you begin to assemble the product, please make sure that all the parts are included in the package and in good condition. A Backrest B Seat x1 x1 C 5-Star base D Mechanism x1 x1 ATTENTION: 1 • Follow the instructions step by step. • To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.
PAGE 2
CHAIR’S FUNCTIONS: (1) Chair height: Pull UP the lever located under the seat on your RIGHT. The chair goes down while sitting on it, or up if you lift your body. (2) Backrest reclining: Pull UP the lever located under the seat on your LEFT, the backrest will recline freely. You can lock the reclining angle by pushing the lever DOWN. (3) Reclining tension: Turn the mechanism’s knob in either direction to apply more or less tension to the reclining function.