Installation Manual

ManualsBrandsTechni Mobili ManualsFurnitureMidback Mesh Task Office Chair. Black

PARTS LIST

ATTENTION: Before you begin to assemble the

product, please make sure that all the parts are

included in the package and in good condition.

ASSEMBLY INSTRUCTIONS

CHAIR STYLE RTA-0097M

Insert the casters (F) in the legs of the

base (C) using pressure, then place the

gas lift (E) in the middle of the base and

cover it with (H) as shown.

Assemble the support (I) to the backrest

(A) using screws (M) and attach the

covers using screws (O) as shown.

Assemble to the seat (B):

- The mechanism (D) using screws (L).

- The armrests (G) using screws (M).

Assemble the mechanism (D) to the

support (I) by inserting the lock pin set

(J) and bending the pin as shown.

Place the top parts over the base parts

making sure the tip of the gas lift enters

into the hole of the mechanism.

Before seating and using the chair for

the first time, make sure that all

screws are properly tightened.

Seat

Backrest

Star Base

Mechanism

Hydraulic

Gas Lift

Covers for

Gas Lift (Set)

Casters

Armrest

Backrest support

with plastic covers

Screws 6x16mm

Spring Knob

Allen wrench

(Backrest, Armrests)

(Mechanism)

x10

Screws 6x25mm

(Mechanism)

ATTENTION:

• Follow the instructions step by step.

• To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.

• Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.

• Using the wrong size of screws on a part could result in damage to the screw or the part

2 3

5 6

Lock Pin Set

Screw 10mm

(Backrest covers)

M (x4)

Disassemble the spring knob (K):

K1 K2 K3 K4 K5

Then insert its bolt (K1) thru the small hole

on the mechanism (D) from underneath as

shown, and re-assemble IN THE EXACT

ORDER SHOWN IN THE ILLUSTRATION.

K5 ----

K4 ----

K3 ----

K2 ----

WARNING:

DON’T PUT

WASHER

HERE!!!

WASHER

GOES

AFTER

SPRING!

---- K1

Summary of content (2 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS CHAIR STYLE RTA-0097M PARTS LIST ATTENTION: Before you begin to assemble the product, please make sure that all the parts are included in the package and in good condition. A Backrest x1 B Seat x1 H Covers for x1 Gas Lift (Set) ATTENTION: 1 • Follow the instructions step by step. • To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.
PAGE 2
CHAIR’S FUNCTIONS: (1) Chair height: Pull UP the lever that is under the seat. The chair goes down while sitting on it, or up if you lift your body. (2) Backrest tilting: Turn the mechanism’s spring knob in either direction to apply more or less tension. WARNING: Please make sure the spring knob was assembled exactly as explained on step 3, otherwise it might detach causing serious injuries.