Instructions / Assembly

STEPS 1 THROUGH 11 IS FOR THE ASSEMBLY OF THE LOWER SECTION
P.5
RTA-7050
P.5
STEP 3
Screws:
🅐
M6x35mm
8
Pcs
🅑
Φ8
x30
8
Pcs
1st: Insert the wooden pins Ⓑ in the corresponding holes on panel ⑦.
2nd: Insert the bolts Ⓐ in the corresponding holes on panel ⑦.
3rd: Insert and align the cam locks Ⓐ in the panels ⑨, ⑩, ⑪ and ⑫ .
4th: Assemble the panels ⑨, ⑩, ⑪ and ⑫ to panel ⑦ as shown and as explained on
page 3.
STEP 1
Separate all the sliders pieces ⑲ according to their shape (no assembly is done here):
- The “Flat” ones go on the side panels and will be used on step 2.
- The “L” shaped go on the drawers and will be used until step 10, please set them aside.
See page 3
With the panels ⑨, ⑩, ⑪ and ⑫ oriented as shown, assemble the “Flat” sliders ⑲ on
the bottom of the panels using screws Ⓔ as shown. Please note the correct holes to use on
the sliders and make sure the wheels face towards the front of the panels.
“Flat” sliders: Will be
used on step 2.
“L” shaped sliders:
Will be used on step 10.
STEP 2
Screws:
🅔
St3x14
8
Pcs
(Front)
(Front)
(Front)
(Front)
(All panels are shown upside-down