Instructions / Assembly

P.11
RTA-7050
P.11
STEP 17
Screws:
🅕
Φ
25 (felt)
4
Pcs
🅖
Φ
22
(laminate)
8
Pcs
Place the following adhesive lables:
- Felt Ⓕ for the screw holes on panel ⑥.
- Laminate Ⓖ for the cam lock holes on panels ③, ④ and ⑤.
(Felt)
Place the upper section assembled in step 17 over the lower section assembled in step 11
according to your preference. The below illustrations show some suggestions.
WARNING:
For safety, when setting the unit in expanded option, do not place the upper section too
close to the edge of the lower section.
STEP 18
CLOSED:
EXPANDED:
DONE! Before you start using the product, make sure that all the screws, bolts, cam
locks, etc. are properly tightened, and read all the warnings listed in the next page.
(Laminate)