Instructions / Assembly

P. 9

RTA-7050

P. 9

Insert and align the cam locks A in the side panels 15 and 16. Then

screw the bolts A into panel 14, and assemble this panel to panels 15

and 16 as shown and as explained on page 4.

Put the drawer upside-down, and assemble the “L” shaped sliders 19

using screws E as shown, making sure the wheel goes towards the back

and the sliders don’t protrude at the bottom. Please note that protruding

sliders rise the drawer 1” and won’t fit in the unit.

STEP 10

Hardware:

ST3x14

Pcs

(NOT INCLUDED)

STEP 9

Hardware:

M6x35

Sets

(Back)

(Top)

Refer to page 4

REPEAT STEPS 8 THROUGH 10

FOR THE SECOND DRAWER

VERY IMPORTANT!

INCORRECT

CORRECT

(Back)

(Top)

(Front)

STEP 11

Insert the drawers into the unit. If they don’t seem to fit, review steps 2

and 10 for the correct assembly of the sliders.

Scan QR Code to

view this step