User Manual

26
The temperature value will now appear orange in the
programming screen indicating that it contains a
modified function.
Note: It is not possible to both increase and decrease
the temperature of the same step.
To enter a temperature gradient
on a step (
Prime
G
only):
On the PrimeG an additional Temperature Gradient
button is available.
• Touch the button below Temperature Gradient to
turn this function on. Next touch the temperature
entry button below this.
A new screen will open which is similar to the simple
temperature entry screen. The maximum temperature
gradient (based on the set hold temperature and the
temperature limits of the unit) will be shown.
• Enter the required value.
• Touch DEL to clear the entry.
• If an entered gradient temperature is invalid, a
prompt will indicate the acceptable range.
• Touch OK to return to the previous screen. The
temperature gradient for the step will now be
displayed.
• Touch OK again to return to the programming
screen.
• Touch Cancel to return to the programming screen
if no changes are required.