Owner's manual

24
Advanced temperature entry
• First ensure the number of cycles for the stage has been set then enter the required hold
temperature as described above.
Note: Increments and Decrements will be inactive unless the number of cycles set is greater than 1.
To
increase or decrease the
step
temperature
per
cycle:
• Touch the step Temp button. This will open the
temperature screen as shown opposite.
• Touch Increments and Decrements.
The increment, decrement and gradient (
3
PrimeG only)
screen will open.
• Touch the button next to the required parameter to
turn it ON.
• Next touch the temperature button to set the
increment or decrement per cycle.
A new screen will open which is similar to the simple
temperature entry screen.
• Enter the required value followed by Back.
• If an entered temperature value is invalid, a prompt
will indicate the acceptable range.
• Touch Accept to return to the previous screen.
• Touch OK to accept the modification and return to
the program.
• Touch Cancel to return to the programming screen if
no changes are required.