Operation Manual

(C) Wake up the Camera
Go back to the NORMAL mode by press the POWER button. The LCD will turn on
and return to the operation mode.
Note: The system need to save the last record file before to weak up the
camera. Sometime need a longer time to process it and restart the camera.
Replace the Batteries
If your Camera does not appear to operate correctly. In some cases the batteries
may be too low to turn on the LCD.
Release 2 latches and open the rear cover (battery pack). Check the battery power
status icon appears on the LCD. When the battery power status icon appeared 1/3 or
empty. That mean the battery power is very low. Press the POWER Button to turn it
off. Remove all these 4 D cell batteries at the same time. Reload 4 brand new
alkaline batteries. Make sure to observe correct polarity. Press the POWER Button
to turn it on. Close the rear cover and lock latches completely.
Battery power status:
Attention: In case the battery power is too low, the battery icon
(see ) will flash 5 times, and the camera will automatically
power off.
Firmware Version Check
Press the POWER Button and hold about 1 second to turn it on.
Slide the TEST/NORMAL switch to TEST.
Press DOWN  DOWN  LEFT  DOWN button then display a TEST MENU.
Press the UP / DOWN button to About.
Press the OK button show a FW-INFO item.
Press the OK button to show the FW version on the top of screen.
Press MENU button to exit TEST menu.