Manual

8
Model: TX-227,TX-230 Article No. 5039,5042, 04/2023
Fixing solar module to mount
⚫ These installation instructions are only intended to describe the installation.
⚫ Be at least 2 people to lift and mount the solar modules.
⚫ Use 4x hexagon head screw M8x20 to mount the solar module to the mount as
shown above.
⚫ Do not stand on the module or the module frame.
⚫ To prevent grease stains on the module, avoid contact with your hands on the glass
surface and ideally wear work gloves.
⚫ Lay the solar module flat on clean surface. Best is to use some protection like a
blanket or cardboard in the size of the module underneath. Be careful not to damage
the glass front.
⚫ Lay the mount on the holes of the solar module you want the mount to be attached
to. First fix the single hole and tighten the hexagon head screw M8x20 with an M8 hex
nut.
⚫ After that fix the hexagon head screw M8x20 to the slotted hole and tighten the M8
hex nut.
Mount to balcony railing
⚫ The solar module is only suitable for installation up to a height of 4m (upper edge
of the module), provided that there is also no public traffic below the module.
⚫ The mounting angle (30°, 35°, 40°), the orientation (west, south, east) as well as
the geographical location influence the yield of the balcony power plant.
⚫ Refer to the technical specifications for maximum wind and snow loads.
⚫ Choose a suitable location for the installation of the solar system, free from
obstacles and with enough space to allow you to adjust the tilt angle (if necessary).
⚫ Be at least 2 people to lift and mount the solar modules.