Manual

4
Model: TX-193 Article No. 4999, 05/2022
Additional safety instructions
When charging lead-acid batteries, flammable gases are produced, so
avoid open flames. ● Only use the charger in a well-ventilated room.
●The charger must not be used in the vehicle or under the closed engine
bonnet. ● Always connect the alligator clips to the battery terminals
before connecting the charger to the mains. ● To stop charging, first
disconnect the mains plug and then remove the alligator clips from the
battery terminals. ● Never allow battery acid to get on your clothes or
skin. Otherwise rinse the affected areas with plenty of water. ●In the
event of eye contact, seek immediate, medical attention.
Features
10A Battery Charger
• Can load AGM, Wet and Gel Batteries (user selectable)
• 6V or 12 V Batteries (the voltage gets selected
automatically)
• Charging current at 6V: 1, 3 or 5A (user selected)
• Charging current at 12V: 1, 5 or 10A (user selected)
• Protection: short circuit, reverse polarity, overheating and
overcharging protection.
Air Compressor
• Max. pressure 120PSI (8bar)
• Pressure unit in bar, PSI, KPA
• Pressure adjustment and auto off if pressure is reached
• 90° adapter (different Adapter included see picture C)