Instructions

 Connect the red connection cable of the WiFi
transmitter to the positive pole of the 12V electrical system (on
board-voltage). You can use any 12V voltage that is switched on or
off with the ignition or the light (rear light). A connection with 12V
continuous plus is not recommended because of the power
consumption. It is also not recommended to connect to the
reversing light as the WiFi transmitter will take about 10 seconds to
establish a connection.
Using the cable clamps
The pictures explains how to use the supplied cable clamps.
1. Put the cable from
the car you want to
connect the WiFi
transmitter with into
the clamp.
2. Insert the 2nd
cable (red or black
cable of the WiFi
transmitter).
3. Close the clamp.
Insert the license plate in the holder
The following drawings show in sequence the insertion of the
license plate.
1. Step
 Slide the license plate into the upper
opening.
 Press the number plate towards
the holder.