Instructions

Commissioning
Check the functionality of the components before installation (a
installed product is excluded from the return). Preparing and
installing the license plate holder and the transmitter unit.
NOTE: You may need a voltmeter to measure the polarity of the
electrical system.
 Break the two locks carefully out of the holder.
 Remove the transport locks carefully. Use a sharp knife or a
tong.
 Attach the license plate holder to the vehicle instead of your
previous license plate holder.
 Insert the camera cable into the trunk compartment and
connect it to the transmitter unit.
 Attach the transmitter unit steady and firm in the trunk
compartment.
 Connect the black connection cable of the WiFi
transmitter to the negative pole of the 12V electrical system (on
board-voltage).