Instructions

 Mark the sensor plug of each sensor or the end of the cable
with the letters A, B, C, D so it is easier to attach them in the right
order to the Control Box.
 Using a steel wire, tied the sensors cables to one end and
guide the other end through into the opening at the underside of the
vehicle until you can see it protrude inside the trunk compartment.
Gently pull on the protruding end until the cables are inside.
NOTE: Take care and gently pull the cables into the inside of the
trunk compartment. Do NOT use force! Avoid placing underneath
sensor cables near high heat source area such as muffler, exhaust
etc.
4. Wiring
 Turn on the ignition so the car is under power (differs by the
model and the age of your car). DO NOT start the engine.
 Make your handbrake on. Then shift the gear to reverse.
 Remove the rear light. Using the electrical tester/multi-meter
to locate the correct power wire for the Reverse Light power line
(this will be the cable of the white reverse light). Mark the correct
wire with positive and negative.
NOTE: You need to find the reverse light power line!
 Shift the gear back to “Parking” for automatic and remove
the vehicle’s key. Car holders with gearshift just remove the
vehicle’s key.