Instructions

Backlight time (Standby)

Enter into Backlight Time menu to set up
standby time, exit menu automatically after setup.
 Press ↑/↓ key  increase and reduce standby time (10-60 seconds)  press
OK key to setup and return to Setup menu.
 Press EXIT key to enter into the standby mode.
Unlock duration

Enter into unlock duration menu.
 Select from 3s, 6s or 8s & confirm with OK.
Tamper alarm

Enter into Alarm settings menu.
 Enable or disable the tamper alarm. It is suggested to enable it to be informed
when the outdoor unit is removed.
Language

Enter into Language menu.
 Press ↑/↓ key  set up “Language”  press OK key to confirm and exit.
 Choose between German, Englisch, Spanish, French, Italian or Czech.
 Press EXIT key to turn back to standby mode.
Pairing

1V1 Match code (put outdoor unit next to the Indoor monitor)
 Select “Creating a network” on indoor monitor  press OK key  enter into
the match code mode.
 Meanwhile, long press the Reset on the outdoor unit, until you hear one “Beep”
sound, then release the reset.
 Indoor monitor displays “Success”, outdoor unit makes “Beep- Beep-Beep”
sounds, means matching successfully.
 If matching failed in 16 seconds, indoor monitor shows “failed”, the outdoor unit
makes ”Beep” sound. Try steps from before again.
NOTE: By default, the monitor is paired with the outdoor unit.

1V2 - Match code
 Choose “Give code (Start the network)” on the first indoor monitor  press OK
key  enter into “Start the network” mode.
 On the new (second) indoor monitor enter into the network menu  choose
“receive code” (Connect to network)  press OK key.

1V3 - Match code
 Choose “Give code (Start the network)” on the second indoor monitor  press
OK key  enter into “Start the network” mode.
 On the new (third) indoor monitor enter into the network menu  choose
“receive code (Connect to network)  press OK key.

Add one more outdoor unit - Match code
 Choose “Give code (Start the network)” on any one indoor monitor in system -》
press OK key  enter into “Start the network” mode.
 On the new (second) outdoor unit: Long press the “reset” until you hear “Beep,
Beep” sound. If match successfully, outdoor unit make three “beep” sounds, and
as No. 2 outdoor unit.
 After all units receive code finished, please use the No. 2 outdoor unit call all
indoor monitors, if all code matched, receive code successfully; if not, repeat the
steps from before.
NOTE:  Inform function: after match code, give code, receive code, please
inform. Inform: tell all units the pieces and ID numbers in the system.  Method of
inform: outdoor unit calls all the indoor monitors (all indoor monitors should be
matched), if there are two outdoor units, use the No. 2 outdoor unit to inform.
NOTE:  The video door phone system support 2 outdoor units with 3 indoor
units at most (2V3).  Giving code among indoor units should do from the 1st to
the 2nd, then the 2nd give code to the 3rd.  Any indoor unit can give code to the
outdoor unit.