User manual

Technical specifications
Input voltage of the battery DC 12V (10.5V–16V)
Output voltage per socket / AC frequency AC 230V / 50Hz nominal
Permanent current / Input current 115A / max. 125A
Output power
1200W (maximum, continuously)
2400W (peak)
Output
waveform
MSW  The power inverter’s MSW [Modified Sine Wave] is
especially suitable for light and heat with max. 1200W. MSW
output can produce "humming" when connected to audio
equipment and is generally unsuitable for sensitive electronics.
Nominal load efficiency 90%
USB output ports 2x 5V USB ports with max. 3.1A (in total)
AC output 2x 230V safety contact sockets
Circuit protection (DC overload) 3x 40A internal fuses
Weight / Dimensions
2.3kg (with cables)
(L) 28.8 x (W) 15.9 x (H) 9.9cm
Package Contents
Power Inverter 1200W TE16, 2x 90cm
connection cable, User Manual
Warnings & Caution
 Use of the device in life support applications where failure of the device can
reasonably be expected to cause the failure of the life support equipment or to
significantly affect its safety or effectiveness is not recommended.  Do not
use the device in the presence of a flammable anesthetic mixture with air,
oxygen or nitrous oxide, and also not near flammable materials, fumes or
gases.  Since the device requires adequate ventilation during operation, do
not block fan or cooling vents and do not cover the device. Do not operate
near car heating vents or in direct sunlight.  Keep the device dry at all times
and disconnect when not in use.  Turn OFF connected equipment before (!)
starting your engine. DO NOT plug a surge protector, line conditioner or UPS
system into the device. If you attach AC extension cords, use the heaviest
practical gauge.  Before connecting a battery charger or adapter, check its
manual to make sure that the technical specifications of the device (including
output waveform) fall within the recommendations of the external battery
charger or adapter.