User manual

TROUBLESHOOTING
No Power on

Fault connection

Turn the inverter’s power switch off; Verify cable are
tightly connected to the inverter and the power source

Battery voltage below 10V

Recharge or replace battery

Equipment being operated draws too much power

Allow the inverter to
cool down. Ensure there’s adequate ventilation around the inverter. Ensure
that load is no more than it’s maximum rating for continuous operation
Low Voltage alarm turns on immediately

The input voltage at input of the Inverter needs to be raised

Recharge/Replace battery or add additional batteries. Run the vehicle engine
when using a 12V DC plug
Low voltage arm is on all the time

Power battery condition with voltage drops

Replace battery

Inadequate power or voltage drops

Check condition of battery cables
and cable leads. Clean or replace as necessary
Low power output

Battery condition may be poor

Recharge or replace a battery

Fault connection  Make sure the battery and Inverter terminal are clean
Inverter does not work after connecting the cables in reverse

The internal protection has disabled the inverter

Contact vendor
company for help
Enjoy your product * Share your experience and opinion on one of the
well-known internet portals such as Amazon or idealo.de