User manual

Remote Control & Functions
Activate (Arm)
PIR sensor can be activated by pressing the remote button shortly or
inserting the device into a cigarette lighter socket. Once PIR sensor
is activated, it takes about 5 seconds until the device is armed.
When armed the blue light flashes every 5 seconds. After human
action is detected, blue light flashes quickly each second and the
siren is noising loudly. When the alarm will work continuous for two
minutes (working current under alarm status is 26mA)
Deactivate (Disarm)
To deactivate the PIR sensor and turn off the alarm sound, press the
button on the remote shortly. You will hear 2x short “beep” and the
blue light stops flashing. The max. distance to disarm the device
before getting back into the car is ~8m on open field.
Shut OFF device
If you press the remote button long (3-4 seconds) you will hear one
short “beep”, and one long “beep” sound. After that the device’s
battery is turned off. Not just the PIR sensor is shut off, the whole
device is shut off for long time no use or for transportation.
All indicator turn off, except the charging indicator (red) when the
device is still plugged into an active cigarette lighter socket. The
device can only be activated/ armed when you plug it into the
cigarette lighter socket again. The remote is not working when
device is shut off.
Note:  It is possible to operate the remote from outside the closed
car through the window.  The remote gives an acoustic and a
visual feedback by pressing the button