User manual

8
4 Product Mounting
Before fix mounting insert batteries, configure the device first and try it out. See
chapter 5.
4.1 WiFi Basis Station TX-91

Device is for indoor use only
Screw installation: If you want to mount the device make sure there is a power socket
nearby and the WiFi signal is good constantly.
Step 1. Dig holes according to
bracket position.
Step 2. Insert a dowel (=expansion
bolt) into the hole.
Step 3. Fix bracket via screw.
Step 4. Buckle the Basis Station into
bracket from top to bottom.
Figure 4-1
Double-sided adhesive tape Installation: If you want to mount the device make sure
there is a power socket nearby and the WiFi signal is good constantly.
Step 1. Before using the double-sided adhesive
tape* (*included), clean the flat surface you want
to stuck it on with nail polish remover or alcohol.
Attention: This can maybe cause damage to the
surface, but will increase the strength of the
connection
Step 2. Stick double-sided adhesive tape (not
included)r on the bracket.
Step 3. Stick the bracket on appropriate position
on wall (That you have cleaned before).
Step 4. Buckle Basis Station into bracket from
top to bottom.
Figure 4-2